Here is my initial ASR1004 Configuration for Netflow.
flow record SW-NTA
match ipv4 protocol
match ipv4 source address
match ipv4 destination address
match transport source-poort
match transport destination-port
match interface input
match interface input snmp
match interface output snmp
collect itnerface output
collect counter bytes
collect counter packetes
flow exporter Solarwinds-1
description Export flows to Solarwinds NTA
destination 10.10.10.58 ------> Solarwinds Server
transport udp 2055
flow monitor FLOW-MONITOR-SW
exporter Solarwinds-1
cache timeout inactive 10
cache timeout active 5
record SW-NTA
Interface GigabitEthernet0/0/0
ip flow monitor FLOW-MONITOR-SW input
ip flow monitor FLOW-MONITOR-SW output
On my Solarwinds Server - NTA Section
Netflow Source Box
Device and Interface have been selected.
Not sure where to go from here to start to recieve flow information. Still digging on community posts.